top of page
We provide accredited independent wall and partition testing services to ensure compliance with the highest standards required.

Wall & Partition System Testing

We provide accredited independent wall and partition testing services to ensure compliance with the highest standards required.

GET A QUOTE

Wall & Partition System Testing

UKTC provide UKAS accredited fire resistance testing of load bearing and non-load-bearing walls and partition systems to both British (BS) & European (EN) standards. 



UKAS Accredited Laboratory

​

Products can be tested in a 3 metre wide furnace and up to 5m high at United Kingdom Testing & Certification, allowing manufacturers to prove performance beyond the standard 3x3m furnace tests available elsewhere in the UK.



​Comprehensive Report

‍Once your test is completed, you will be issued with a comprehensive and internationally recognised test report accessible by your very own online portal with a full video of the test conducted.


​

Test Standards


We are accredited to test to the following standards at our UK based fire resistance laboratory:

  • BS EN 1364-1:2015

  • BS EN 1365-1:2012

  • BS 476-21:1987 § 8

  • BS 476-22:1987 § 5



Loadbearing v Non-Loadbearing Wall Tests

Loadbearing Wall Fire Testing


To help against collapse or failure of a building, there is a requirement for load bearing systems to have a minimum standard of fire resistance. Such wall or partition wall must maintain the fire integrity and independent structural stability of buildings. The fire resistance of load bearing systems can be demonstrated through destructive fire test evidence.

 

The measurement for this is called Load-bearing Capacity (R). The walls ability to maintain a load. This is determined by measuring the vertical deflection of the wall.

Non-Loadbearing Wall Fire Testing


The spread of fire within a building can be restricted by using fire resisting walls and partition walls to separate the building into compartments and allow means of escape. The fire resistance of non-load bearing systems can be demonstrated through destructive fire test evidence.



We provide accredited independent fire door testing services and fire resistance testing for door hardware and ironmongery.

Doorsets and Hardware Testing

Start Now
We provide accredited independent glazing systems testing services to ensure compliance with the highest standards required.

Glazing Systems Testing

Start Now
The purpose of fire resistance testing is to confirm compliance with building codes and standards, ensuring the seals maintain their protective properties during a fire.

Penetration Seals Testing

Start Now
The purpose of fire resistance tests on linear joint seals is to assess the effect of a linear joint seal on the integrity and insulation of the construction.

Linear Joint Seals Testing

Start Now
Horizontal floor & ceiling fire testing services from a UK-based laboratory.

Floors and Ceilings Testing

Start Now
​UKTC's smoke leakage chamber enables comprehensive and UKAS accredited smoke leakage testing performed to either BS EN 1634-3:2004 or BS 476-31.1:1983.​​

Smoke Leakage Testing

Start Now
Coming Soon to UKTC's laboratory and test facility, a purpose-built acoustic test suite in accordance with BS EN ISO 10140-5:2021.

Acoustic Testing

Start Now
This procedure specifies a method of test for determining the rection to fire performance of construction products when exposed to thermal attack by a single burning item (SBI).

Single Burning Item (SBI) Test

Start Now
This test identifies products that will not, or not significantly, contribute to fire, regardless of their end use.

Non-combustibility Test

Start Now
This method specifies a test for determining the ignitability of products by direct small-flame impingement under zero impressed irradiance using vertically oriented test specimens.

Flame Source Test

Start Now
This test determines the potential maximum total heat release of a product when completely burned, regardless of its end use.

Gross Heat of Combustion Test

Start Now

other tests we provide

Trusted to ensure

Underline_2.png

Our team consists of the brightest scientists, engineers, researchers and technicians from the built environment industry. We share a common goal - to enable greater protection of lives and assets - and are ready to help you.

SPEAK TO US

FREQUENTLY ASKED QUESTIONS

bottom of page